Hi,
I'm Francesco and with my friend Davide we are building a Menestrel HN700. Anyone of you met Davide at the rassemblement in August.
So we have a little doubt about the stabilizer rotation angle. We installed the cloche and the steel cables following the drawings and the maximum excursion we could obtain are +21° and -21°.
I read over Cahier de Menestrel that excursion angle must be +-30° but I'm quite sure that is not possible.
How much the angle must be following your experiences?
Thx so much
Francesco
stabilizer rotation angle
-
- sympathisant
- Messages : 1
- Enregistré le : 22 sept. 2009 12:50
Re: stabilizer rotation angle
Hello Francesco
I will not be able to help you for the HN700 but my plane is a HN434 and values should also be +/-30°. Physicaly I did not succeed to have more than +25 and -28° and it's realy enough for flying in good safety conditions.
+/-21° are smaller values so I can't conclude anything, but I hope you will have some datas from our HN700 owners in this forum.
Laurent
I will not be able to help you for the HN700 but my plane is a HN434 and values should also be +/-30°. Physicaly I did not succeed to have more than +25 and -28° and it's realy enough for flying in good safety conditions.
+/-21° are smaller values so I can't conclude anything, but I hope you will have some datas from our HN700 owners in this forum.
Laurent