stabilizer rotation angle

If you are english you can post here!
Vitello
sympathisant
Messages : 1
Enregistré le : 22 sept. 2009 12:50

stabilizer rotation angle

Messagepar Vitello » 09 sept. 2010 12:29

Hi,
I'm Francesco and with my friend Davide we are building a Menestrel HN700. Anyone of you met Davide at the rassemblement in August.
So we have a little doubt about the stabilizer rotation angle. We installed the cloche and the steel cables following the drawings and the maximum excursion we could obtain are +21° and -21°.
I read over Cahier de Menestrel that excursion angle must be +-30° but I'm quite sure that is not possible.

How much the angle must be following your experiences?

Thx so much
Francesco

PELLETIER Laurent

Re: stabilizer rotation angle

Messagepar PELLETIER Laurent » 10 janv. 2014 08:23

Hello Francesco

I will not be able to help you for the HN700 but my plane is a HN434 and values should also be +/-30°. Physicaly I did not succeed to have more than +25 and -28° and it's realy enough for flying in good safety conditions.

+/-21° are smaller values so I can't conclude anything, but I hope you will have some datas from our HN700 owners in this forum.

Laurent